Tap repair Sydney
Dripping tap in the kitchen, bathroom or laundry? Our tap plumbers tell you whether it needs a new washer, a new cartridge or a whole new tap, and fix it on the spot with fully stocked vans. We repair and replace taps anywhere in Sydney, day or night, and charge nothing to call out.
Call 24 hours02 9099 9138- $0 Call Out
- Within the Hour
- 0% Interest Available
- Licensed #379146C
Book a plumber
Tell us where the tap is, what type it is (two handles or one lever) and how it leaks. A photo helps. If a tap will not shut off, ring us rather than fill in the form.
Our iron clad guarantee
- Complimentary safety inspection includedEvery job comes with a complimentary whole-system safety inspection for complete peace of mind.
- 100% satisfaction or we fix it freeNot happy with our work? We’ll come back and make it right at no extra cost.
- Full year warranty on all partsEvery component we install is backed by a comprehensive 12-month warranty.
- Lifetime guarantee on workmanshipOur installation work is guaranteed for life. If it fails due to workmanship, we’ll fix it free.
Tap replacement & repair services
Leaking tap? Kitchen or bathroom overdue for an update? At Rapid Service Plumbing, we’re ready to help with all your needs in professional tap replacement & repairs.
Plumber within the hour
Plumber within the hourPlumber within the hourPlumber within the hourPlumber within the hourDoes your leaking tap need a tap repair plumber today?
Most dripping taps are a small job. A few are not, because water is running that you cannot stop, or it is soaking something it should not.
Call us now
02 9099 9138Book a repair
Call us now
The tap will not turn off at all
Water keeps running even with the handle fully closed. Turn the isolation tap under the sink or basin off, then call us.
Book a repair
A slow drip from the spout
Usually a worn washer or cartridge. It wastes water and stains the basin, but it will not flood the room.
Call us now
Water spraying from the base or handle
A split body or a failed seal lets water out under pressure. It can reach the cabinet and the floor within minutes.
Book a repair
A damp ring around the handle
A small weep at the spindle is normally a worn seal. It is worth fixing before it works loose.
Call us now
A wet cabinet under the sink
A flexible tap hose or its fitting has failed, and the water is going into the cupboard, not down the drain.
Book a repair
A tap that is stiff or gritty to turn
Scale or a worn cartridge. Annoying and easy to put off for a daytime visit.
Call us now
A tap that has snapped off or come loose
A broken fitting can let water out with no way to close it, particularly on an older wall tap.
Book a repair
Low flow from one tap only
Often a blocked aerator or a tired cartridge. Hot and cold from every tap being weak is a different problem.
Not sure how bad your leaking tap is?
Ring us and a licensed plumber will say whether to shut it off or leave it.
Answered 24/7$0 call out fee
We fix leaking taps Sydney wide
Tired of that drip-drip-drip? Sick of that worn & tired old look and feel? Your taps shouldn’t just look stylish, they play a major role in the smooth and functional operation of your home.
- Licensed #379146C
- Fully stocked van
- Honest pricing
We fix leaking taps Sydney wide
Did you know that a simple tap leak can waste tens of thousands of litres of water each year? Did you know a faulty tap risks damage to your home, furniture, equipment, floors and even your foundations? Did you know leaks, limescale, rust and mineral build-up promote the thriving of unhealthy mould & mildew?
They may seem simple enough, but you may need tap replacement & repairs if:
- Washers, O-rings & jumper valves are broken or worn
- The taps or associated plumbing pipes are broken or damage
- Your tap installation was done incorrectly.
The friendly and fully-licensed team of plumbers at Rapid Service Plumbing have the knowledge, tools and hands-on experience to fix or completely replace the taps at your place that have seen better days. Our expert services in tap replacement and repairs include:
- Recutting washer seats
- Full hot/cold tap servicing
- Cleaning of bonnets & spindles
- Replacement of O-Rings, fibre & other washers
- Lubrication/refit of spindles
- Refit & sealing of flanges and handles
From pillar taps to mixer taps, monobloc taps to washer taps, ball taps to cartridge taps, disc taps, spindle taps and beyond, we do it all! We can even complete the job with professional water filter installation - and our 100% lifetime workmanship guarantee applies on every single job, big and small.
Rapid Service Plumbing’s immaculately-presented tap technicians have been working on, supplying and installing all major styles, brands and configurations across Sydney & surrounding areas for years. It’s why we’ve earned a reputation not just for swiftly repairing leaking taps Sydney wide, but for our advice and guidance in matching the perfect choice of tap style, brand & materials to your home, personal preferences and budget.
Talk to a plumber now
Free advice over the phone at any hour, and no call out fee.
Need help selecting your next taps?
If you’re in the market for new tapware, Rapid Service Plumbing’s fast & affordable full tap replacement & installation services are in full compliance with NSW regulations and the Australian Plumbing Code (PCA) - so you know that we know what we’re doing!
Tap repair or replacement: what your tap type decides
The tap on your basin or sink tells us what is probably wrong and whether a repair is worth doing. Pick the one that looks like yours.
A drip from the spout that stops when you tighten the handle hard points to a worn rubber washer or a pitted seat inside the tap.
We isolate the water, replace the washer and reface the seat where we can, so the new washer has something flat to seal against.
If the body is corroded or the spindle is worn out, a new washer will not hold, and we tell you it is time to replace the tap.
Old taps with chipped chrome and rough handles are usually cheaper to replace than to keep patching.
These quarter turn taps drip when the cartridge wears out or scale gets between the discs. The handle often feels loose or notchy.
We fit a new cartridge matched to the tap, which is a quick repair when the tap is still in good condition.
If a matching cartridge is no longer made, replacing the tap is the honest option, and we explain that before we start.
A single lever mixer that drips, swings loose, or gives you only hot or cold has a worn cartridge, a split O ring or a cracked body.
We repair the mixer if the body is sound, or replace it and connect new flexible hoses so the old ones do not fail next. A new kitchen tap or bathroom tap installation is done with the isolation taps tested.
Pull out and swivel spouts also leak at the joint. We seal or replace that section, and check the hoses under the sink.
A garden or laundry tap that drips all day wastes more water than most people expect, and it shows up on the Sydney Water bill.
We repair the washer or replace the tap, and check the vacuum breaker so water cannot flow back into the house supply.
We look at your water pressure at the same visit, because high pressure wears out washers and cartridges early.
How it works
How our tap plumbers work, from the first drip to a tap that closes properly.
Describe the tap
Call 02 9099 9138 or send the form with the tap type and a photo. We tell you what is likely wrong and bring the washers, cartridges and fittings to suit.
Work order- $0 call out
- Answered 24/7
- Suburb and problem noted
Licensed #379146C, Sydney wide
Diagnose, then decide
We shut the water off at the tap, open it up and show you what failed. Then you get a straight answer on repair or replacement, with the price, before we do either.
Work order- Licensed #379146C
- Fully stocked van
- Within the hour
Licensed #379146C, Sydney wide
Test every outlet
We turn the tap on and off, check the hoses and the isolation taps, and look under the sink for any weep. Parts carry a 12 month warranty and the workmanship is guaranteed for life.
Work order- Free safety inspection
- 12 month parts warranty
- Lifetime workmanship guarantee
Licensed #379146C, Sydney wide
What tap repair and replacement costs in Sydney
A washer costs very little and a designer mixer does not, so a tap repair cost depends on what is inside your tap and what you choose to put in its place. We quote first and start second.
Repair or replace
A washer or cartridge is a short visit. If the tap body is worn, replacing it costs more now and saves repeat call outs later.
The tapware you choose
A basic chrome tap and a premium mixer are very different prices. You can supply your own or we can supply one.
Hard to reach fittings
Taps on a wall, a freestanding bath or a stone benchtop take longer than a basin tap with a cupboard under it.
Isolation taps and hoses
If the isolation tap under the sink will not close, or the flexible hoses are old, we replace those at the same visit.
Water pressure and age of the plumbing
Old galvanised pipe or very high pressure can mean extra work behind the tap. We tell you before we start.
$0 call out fee
Any hour,
any day
- The price agreed before work starts
- Parts on the van, so most taps are done in one visit
- Licensed #379146C, every plumber
If the leak is a water pressure problem
A tap that keeps failing can point to a pressure issue in the house. Our guide explains water hammer and what to do about it.
Every Question About Water Hammer AnsweredAustralia’s favourite plumbing service provider
4.7
From over 340 reviews, Australia wide
“Fantastic service and fairly priced. Highly recommend!”
“Anthony and Addison provided great knowledge and solutions to assist with our plumbing issue. Many thanks!”
“Sam from Rapid Service Plumbing came out and gave us a quote for job. He provided excellent information and was super clear about the work.”
“Best service of all time, thanks SO much to the whole team”
“Sam, champion bloke. Great service. Greatly appreciated. Cheers mate.”
More plumbing services
All servicesKitchen Plumbing
View kitchen plumbingWater Leaks
View water leaksGas Fitting
View gas fittingDrainage Solutions
View drainage solutionsHot Water System
View hot water systemEmergency Plumbing
View emergency plumbingBlocked Drains
View blocked drainsBathroom Plumbing
View bathroom plumbingAreas we cover
258 suburbs across 9 regions of Sydney, from the Hawkesbury to the Shire, with a plumber on call in each.
Choose your region
Frequently asked questions
Fast, affordable tap repairs and replacement
If you’re tired of the drip-drip-drip, need fast service to restore functionality to your home and guidance for the right tapware selections, Rapid Service Plumbing is your one-stop-shop for all your needs in tap replacement and repairs. Book an appointment with one of our friendly local Sydney plumbers today.
How much does tap replacement cost?
Customers often ask about the cost to replace a tap and what the price includes. For your peace of mind, we offer upfront, fixed pricing with no hidden costs. Our quotes cover parts, labour, and call-out fees, so you know exactly what to expect before we start.
Are you fully licensed, insured, and do you guarantee your workmanship?
Absolutely. Our team is made up of licensed and fully insured plumbers, and all our work comes with a satisfaction guarantee. We only use top-quality tapware and provide written warranties for every new tap installation.
How soon can you replace my tap - and do you offer after-hours service?
We know a leaking or broken tap can’t wait. That’s why we offer fast same-day service across Sydney. Emergency tap replacements and after-hours support are also available, so help is always just a call away.
Is it cheaper to repair a leaking tap or replace it?
A washer or cartridge on a tap in good condition is the cheaper job. If the body is corroded, the finish is flaking, or a replacement cartridge is no longer made, repair only delays the next leak. We show you what failed and give both prices before we start.
How do I know what type of tap I have?
Two handles that you turn several times usually have washers. Quarter turn handles are cartridge or ceramic disc taps. A single lever that moves up, down and sideways is a mixer. If you are not sure, send us a photo and we will tell you.
How much water does a leaking tap waste?
More than it looks. A steady drip runs through thousands of litres a year, and an outdoor tap left running wastes far more. That water is billed to you by Sydney Water, so fixing a drip is worth doing even when it seems minor.
Can you replace a kitchen or bathroom tap I bought myself?
Yes. Bring the tap to the visit or have it delivered before we arrive. We check it fits your sink or basin and the hole spacing, connect it with new hoses and test it. We can also supply a tap if you would like us to.
Does tap installation need a licensed plumber in NSW?
Replacing a tap connects to the water supply, so in NSW it is licensed work done to the plumbing code. We give you the paperwork for the job. Swapping a shower head or tap handle only is different, but if you are unsure, call us before you start.
How do I stop a tap leaking until the plumber arrives?
Turn the small isolation tap on the pipe under the sink or basin clockwise to close it. If there is no isolation tap, close the main water tap at the meter or the house, then call us. Place a bucket or towel to catch drips.
Which parts of Sydney do you do tap repairs in?
We work in every Sydney region, from Western Sydney and the Hills District to the Eastern Suburbs, Inner West, North Shore, Northern Beaches, Canterbury-Bankstown, South West Sydney and the Sutherland Shire. Whoever is closest drives over in a van carrying the parts.
How much does it cost to replace a tap in Sydney?
It depends on the tap you choose and how easy it is to reach. A plain basin tap is a short job and a wall mounted or stone benchtop mixer is longer. Nothing is charged to attend, and the price is agreed with you first.
Get a free quote
Get obligation free plumbing quotes & guaranteed workmanship from our 5-star rated local Sydney plumbing team
